New Tires Lt 2wd Leather Rear Dvd Entertainment Reverse Sensors Remote Start 5.3 on 2040-cars

Auto blog

This is your 2014 Chevrolet SS

Think you've waited long enough for this? If so, then you'll want to savor the high-res photos we've so far been given of the 2014 Chevrolet SS, the first rear-wheel-drive performance sedan from The Bowtie in 17 years.
We all know its our version of the brand new VF-model Holden Commodore, but what's under the hood that earns the appellation "performance?" A 6.2-liter LS3 V8 engine producing 415 horsepower and 415 pound-feet of torque. That's 35 hp and lb-ft less than the same engine is expected to produce in the 2014 Chevrolet Corvette. Chevrolet says the sedan will get from 0-to-60 miles per hour "in about five seconds."
Shifting comes courtesy of a six-speed automatic with paddles on the steering wheel, while stopping arrive via four-piston Brembo calipers up front, a single sliding piston in back. The forged aluminum wheels are 19-inchers all around, each set supporting right around 50 percent of the sedan's weight, and the aluminum hood and trunk are meant to keep the center of gravity low.

GM exploring ways to raise half-ton Duramax diesel tow rating

Lots of truck owners cheered when GM announced fuel economy numbers for the 2020 Chevrolet Silverado with the 3.0-liter Duramax diesel inline-six. Even after Ram let loose its EPA mileage ratings for the 2020 Ram 1500 EcoDiesel, the Chevy oil-burner still took the trophy. The victory was years in the making, GM engineers spending an entire four-year development cycle refining the LM2 Duramax to increase mileage. The tradeoff, as well all know by now, is towing; the Duramax in half-ton duty pulls a maximum 9,300 pounds in the Silverado. Rivals across town can do more, the Ford F-150 PowerStroke rated at 11,500, the Ram 1500 EcoDiesel game to pull 12,560. GM engineer John Barta told Muscle Cars & Trucks that more hauling chops could be on the way, explaining, "We’re actually looking at upgrading some of the materials around (the engine bay) to see if we can maybe raise our tow rating." Engine bay materials are at issue due to thermal complexities underhood. John Barta, GM's assistant chief engineer of diesel engine controls, said the Duramax's inline-six configuration allowed engineers to get emissions hardware like the combined selective catalytic reduction, diesel oxidation catalysts, and diesel particulate filter unit closer to the engine, where it heats up quicker, getting emissions down quicker. But that filter puts another heat source in those confines, enforcing a cap on the tow rating to keep the engine and other systems from overheating. "If you look under the hood," he said, "youÂ’ll see a significant amount of silver ‘moon tapeÂ’ around to make sure things arenÂ’t getting overheatedÂ… if we were to go up in higher towing, which we can, we start impacting the possibility of deteriorating some of the components.” There isn't much space for more grille, so swapping for a better grade of "moon tape" or a different kind of material could reduce engine bay heat, extracting a higher tow rating in the process.  It's important to note a point Barta's been making for months about the Duramax figures, though. "Even though itÂ’s nice to brag about big numbers, in reality, light duty customers are not towing that large with their trucks," and, "We do know that (95 percent) of our light duty customers donÂ’t tow over 9,000 pounds." On our First Drive of the 2020 Silverado diesel we called out the tow rating, but emphasized that the Chevy and GMC have more important challenges to overcome.

GM reintroduces Tripower name in the worst way possible

The story of General Motors' use of the Tripower moniker begins way back in 1957, when Semon E. "Bunkie" Knudsen, then General Manager of GM's Pontiac division, directed his engineers to inject more performance into his brand's line of V8-powered automobiles. Fuel injection was an option, but hot rodders flocked instead to Tri-Power (marketed way back when with a hyphen), which grafted a trio of two-barrel Rochester carburetors onto a single intake manifold. A legend was born. And that legend was born of performance. At idle and when full power wasn't required, Pontiac's Tri-Power system used just the middle carburetor, which helped make the setup easier to tune. Depending on the year and model, either a vacuum system or a mechanical linkage opened up the two outer carbs, thereby switching from two barrels to six, and allowing the engine to take in more fuel and air. And it was an easy marketing win – six barrels is better than four barrels, right? Because performance! So, when news filtered in that GM has resurrected the Tripower name, those of us who grew up attending classic car shows and wrenching on old Pontiacs did a double-take. And then we all collectively sighed. Turns out that today's Tripower refers to a trio of fuel-saving measures that include cylinder deactivation, active thermal management, and intake valve lift control, according to Automotive News. And, at least for now, it applies to GM's line of fullsize trucks powered by a 2.7-liter turbocharged four-cylinder engine. We're all for saving fuel whenever possible. And we have zero say in how any automaker chooses to market its products and technologies. But, we'll offer our two cents anyway: Relaunching a storied name from the past is fine. Relaunching a storied name from the past while completely overlooking the reasons the name got famous in the first place is only going to irritate the people who remember the name in the first place. Couldn't they just call this new technology package something else? Related Video: News Source: Automotive NewsImage Credit: Getty Green Marketing/Advertising Chevrolet GM Pontiac Automotive History Truck chevrolet silverado