Dealer Trade, Clean, 5.3 L V-8, Straight Body And Clean Interior on 2040-cars

Auto blog

NHTSA could add 1M cars to GM recall

The Detroit Free Press is reporting that the National Highway Traffic Safety Administration may expand a recall campaign for faulty brake lamps. The agency is currently looking into complaints that certain 2004-2011 Chevrolet Malibu models as well as some 2007-2009 Saturn Aura sedans may have brake lights that do not illuminate when the driver presses the pedal. Alternatively, the lamps may also illuminate without input from the driver. General Motors recalled 8,000 Pontiac G6 models from the 2005 model year for the same problem, and NHTSA is currently investigating whether to add 550,000 more G6 models built between 2005 and 2009 to the list for the same issue.
In addition, investigators are currently examining 97 complaints from Malibu and Aura owners with the same trouble. If NHTSA adds those models to the recall campaign, more than one million units could be covered. GM, meanwhile, says there have been no accidents or injuries as a result of the problem.

GM recalls select Chevy Cruze, Sonic and Buick Verano models over airbag issue

General Motors is recalling certain 2012 Buick Verano, Chevrolet Cruze and Sonic models due to a defect in the driver's airbag system. According to the National Highway Traffic Safety Administration, the airbag has a shorting bar which may contact two internal terminals. If that happens during a crash, the supplemental restraint may not deploy, increasing the risk of driver injury. The recall includes a total of 2,949 units.
GM will contact owners and replace the steering wheel airbag coil at no cost. At this point, it's unclear when the recall will begin, though owners may contact the automaker at 1-800-521-7300 for more information. You may also take a closer look at the full NHTSA notice below.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck