1957 Cadillac Eldorado Seville; 2d Hard Top; Highly Optioned ; Only 2100 Built! on 2040-cars

Auto blog

2016 Cadillac ATS-V First Drive [w/video]

If you get hot and bothered for hot-rodded sedans and coupes, you probably know that Germans have long dominated that cutthroat scene. For years, the Audi RS/BMW M/Mercedes-AMG triumvirate has ruled the microcosm of grunty, mid-level luxury cars. But a funny thing happened when Cadillac's first V car hit the market in 2004. Since the CTS-V crashed the high horsepower party, German tuning houses started thinking less about the "Daddy's Caddy" stereotypes and more about the next imminent threat – in this case, the inevitable high-horsepower spinoff of the smaller, nimbler Cadillac ATS. The standard ATS' defense against the German triad hasn't been triumphant so far (GM's Michigan plant was idled for three weeks in 2014 due to excess inventory), but the souped-up 2016 Cadillac ATS-V presents a fresh bid to put the Teutonic competition on alert. The ATS-V's flared bodywork and quad exhaust pipes offer bits of visual shock and awe, but significant hardware upgrades back up the go-fast looks. Front and center is a twin-turbocharged, 3.6-liter V6 with reworked internals including a charge-air cooler, titanium connecting rods, and titanium-aluminide turbines. The new engine produces 464 horsepower and 445 pound-feet of torque, up a staggering 262 hp and 173 lb-ft compared to a base, four-cylinder ATS. Those output figures eclipse the BMW M3/M4 (425 hp, 406 lb-ft) and Audi RS5 (450 hp, 317 lb-ft), but lag slightly behind the V8-powered Mercedes-AMG C63 (476 hp, 479 lb-ft), and more so the C63 S (503 hp, 516 lb-ft). The chassis benefits from several structural braces, most notably a shear panel intended to boost front-end stiffness. Extra poundage from the add-ons are minimized through lighter-weight materials – in the case of the shear panel, stamped aluminum. Cadillac says though it intended to make the ATS the quickest car in its segment (stated 0-60 mph times between 3.8 and 3.9 second virtually match the BMW M4 and Mercedes-AMG C63 S' 3.9 figure), the development team says they also focused on subjective qualities like turn-in quickness and steering response. As such, toe links have been replaced with ball joints, mounts have been retuned, and reworked magnetic damping offer greater responsiveness. Six suspension bushings have been stiffened and ten have been completely redesigned, and the Performance Traction Management system that tames beasts like the Corvette Z06 and Camaro ZL1 also helps lay down power in the ATS-V.

Cadillac toned down ATS Coupe design due to customer feedback [w/poll]

Automakers always face a difficult decision when it comes to styling their cars. Design them too blandly and nobody will get excited about them. But style them too aggressively and they'll often end up turning off potential buyers.
Cadillac, for its part, is no stranger to aggressive design, but when it came to the new ATS Coupe, it elected to tone things down a bit. Speaking with The Detroit News in a wide-ranging interview, Cadillac design director Bob Boniface revealed that the original design for its compact coupe was edgier - closer to that of the CTS Coupe - with a wedgier profile, a more steeply raked beltline and a more severe grille. But potential customers surveyed in clinics apparently didn't like it. They found it looked heavy, inefficient and not fun to drive. So Boniface and his team literally went back to the drawing board and "took as much visual mass out of the car as [they] could." The resulting coupe, while handsome, looks far more similar to its four-door companion than did Cadillac's CTS.
What do you think, does the new ATS Coupe look just right, or is it too conservative? Voice your opinion in our quick online poll.

Cadillac issues stop sale on ATS to recall 82k units

Cadillac is issuing a recall on 82,620 examples of the 2013-2016 ATS worldwide to fix a compliance issue with the sunroof controls. Until a service bulletin goes out to take care of things, there's also a stop sale on the luxury compact in the United States, The Detroit News reports. Of the affected models, 63,665 are in the US, according to a statement sent to Autoblog, and 7,922 of them are in Canada. The problem is actually the same issue as a recall on nearly 59,000 examples of the 2013-2015 ATS in the US in February. In them, the controls for the tilt and slide of the roof aren't recessed enough to meet government standards for the force necessary to operate the buttons. The Feds believe that someone could accidentally activate the auto-close and potentially be at risk. At the time, Cadillac dealers installed a new trim plate to add the needed clearance. In the latest update, the company is adding the 2016 model year, and according to The Detroit News, 70 percent of the cars from the original campaign also need another new trim plate. Unsurprisingly for such a minor defect, there are no known crashes, injuries, fatalities, or customer complaints related to this issue, according to the announcement by General Motors. Cadillac ATS Statement: General Motors is recalling 63,665 Cadillac ATS sedans in the United States from the 2013-2016 model years because the power-operated roof panel systems on these vehicles will auto-close when the non-recessed portion of the "Slide" or "Tilt" switches are pressed and the roof panel is open. Because these switches are not fully recessed, they can be actuated with less force than required to comply with applicable federal standards. GM knows of no crashes, injuries or fatalities related to this issue and has received no customer complaints. The total population of the recall including Canada, Mexico and exports is 82,620. Transport Canada Recall # 2015322 Recall Date 2015/07/21 Notification Type Compliance Mfr System Electrical Manufacturer Recall Number 15568 Units Affected The number of vehicles or components affected by the recall. 7,922 Category Car Recall Details Certain vehicles equipped with power-operated sunroof system may fail to conform to Canada Motor Vehicle Safety Standard (CMVSS) 118 - Power-Operated Window, Partition and Roof Panel Systems.