2003 Cadillac Deville Sedan 72k Org Miles V-8 Auto Clean Carfax Rides Great on 2040-cars

Auto blog

GM recalls 61k more vehicles in three campaigns

Following a stop-delivery order for its new midsize trucks and a rash of recent recalls, General Motors is issuing three more campaigns covering 60,575 vehicles in North America with 57,182 of them in the US. As of October 1, the automaker has issued a total of 74 recalls (see the ridiculously long chart to the right) this year covering 26,495,070 units in the US.
The largest campaign covers 46,873 examples in the US of the 2008-2009 Pontiac G8 and 2011-2013 Chevrolet Caprice Police Patrol Vehicle imported from Australia. It's possible for the driver's knee to hit the key and make it move from the "Run" to "ACC" position while driving. GM says its Holden division is developing a fixed-blade key that's supposed to fix the problem by only allowing it to rotate toward the "On" position. There has been one crash caused by this fault but no injuries or fatalities.
The second recall is for 10,005 units of the 2004-2007 Cadillac CTS-V and 2006-2007 Cadillac STS-V because "the fuel pump module electrical terminal may overheat." This can cause a flange to melt and allow the pump to leak fuel. GM specifies that the remedy for the CTS-V is replacing the fuel module and fuel tank jumper harness, but it doesn't specify how the STS-V is being repaired.

2016 Cadillac ATS-V First Drive [w/video]

If you get hot and bothered for hot-rodded sedans and coupes, you probably know that Germans have long dominated that cutthroat scene. For years, the Audi RS/BMW M/Mercedes-AMG triumvirate has ruled the microcosm of grunty, mid-level luxury cars. But a funny thing happened when Cadillac's first V car hit the market in 2004. Since the CTS-V crashed the high horsepower party, German tuning houses started thinking less about the "Daddy's Caddy" stereotypes and more about the next imminent threat – in this case, the inevitable high-horsepower spinoff of the smaller, nimbler Cadillac ATS. The standard ATS' defense against the German triad hasn't been triumphant so far (GM's Michigan plant was idled for three weeks in 2014 due to excess inventory), but the souped-up 2016 Cadillac ATS-V presents a fresh bid to put the Teutonic competition on alert. The ATS-V's flared bodywork and quad exhaust pipes offer bits of visual shock and awe, but significant hardware upgrades back up the go-fast looks. Front and center is a twin-turbocharged, 3.6-liter V6 with reworked internals including a charge-air cooler, titanium connecting rods, and titanium-aluminide turbines. The new engine produces 464 horsepower and 445 pound-feet of torque, up a staggering 262 hp and 173 lb-ft compared to a base, four-cylinder ATS. Those output figures eclipse the BMW M3/M4 (425 hp, 406 lb-ft) and Audi RS5 (450 hp, 317 lb-ft), but lag slightly behind the V8-powered Mercedes-AMG C63 (476 hp, 479 lb-ft), and more so the C63 S (503 hp, 516 lb-ft). The chassis benefits from several structural braces, most notably a shear panel intended to boost front-end stiffness. Extra poundage from the add-ons are minimized through lighter-weight materials – in the case of the shear panel, stamped aluminum. Cadillac says though it intended to make the ATS the quickest car in its segment (stated 0-60 mph times between 3.8 and 3.9 second virtually match the BMW M4 and Mercedes-AMG C63 S' 3.9 figure), the development team says they also focused on subjective qualities like turn-in quickness and steering response. As such, toe links have been replaced with ball joints, mounts have been retuned, and reworked magnetic damping offer greater responsiveness. Six suspension bushings have been stiffened and ten have been completely redesigned, and the Performance Traction Management system that tames beasts like the Corvette Z06 and Camaro ZL1 also helps lay down power in the ATS-V.

2016 Cadillac CT6 to get an aluminum body?

Well this is interesting: A hot-off-the-press report in Automobile claims the coming Cadillac CT6 will have an aluminum body. Most write-ups on the CT6 claim it will have a body that's a combination of aluminum and high-strength steel - Automobile itself wrote of "high-strength steel, aluminum, and steel stampings" in October. An all-aluminum body would be quite the reversal, contradicting the last four months of reportage and company statements on the matter. Mark Reuss, EVP of global development at General Motors, told The Detroit News in October, "We will create with the CT6, the world's most advanced body structure... [and] it's not aluminum. It's a stronger, smarter, safer premium luxury vehicle." It echoed the earlier Automobile story in saying the CT6 would use GM's "patented welding technology with high-strength steel, aluminum and steel stampings and castings." That same month, the Wall Street Journal ran a piece titled, "GM Won't Follow Aluminum Strategy in Future Cars," in which Reuss said, "making big statements around all carbon fiber, all aluminum, all magnesium, they're very interesting," and that GM wouldn't be doing it. That piece also circled back to a material mix and GM's special welding process, saying the CT6 "will have a body made of aluminum, high-strength steel and other materials, and will be 100 kilograms (220 pounds) lighter than a similar-sized car made of high-strength steel." We don't know what kind of body Cadillac's new assault on luxury is going to wear, but now we can't wait to find out. Featured Gallery Cadillac Elmiraj Sedan: Spy Shots View 22 Photos News Source: AutomobileImage Credit: Chris Doane Automotive Cadillac GM Luxury Sedan aluminum cadillac ct6