2014 Buick Verano Convenience on 2040-cars

Auto blog

GM follows up Lambda CUV stop-sale with tire recall

In late January, General Motors announced a stop-sale for about 6,281 examples of the 2015 Chevrolet Traverse, GMC Acadia and Buick Enclave because of the possibility for the treads cracking on their 18-inch Goodyear Fortera HL tires. At the time, GM said that this would also eventually lead to a safety campaign to repair the problem, and the National Highway Traffic Safety Administration has just published those details. GM's recall covers 5,876 of the three Lambda platform crossovers to replace their tires. According to NHTSA, if the treads crack, there could be a loss of pressure and possible failure. Goodyear already announced its own recall of the tires after internal testing found small tread cracks. The company did not believe this was safety issue, but the problem did put the rubber out of compliance with federal laws. The business's safety campaign covered an estimated 48,512 tires. Of those, around 32,000 were reportedly made for GM to either be fitted to vehicles or sold as replacements. The remainder went to the aftermarket. Goodyear's portion of the recall is expected to begin around February 20. RECALL Subject : Tire Tread Cracking/FMVSS 110 Report Receipt Date: JAN 28, 2015 NHTSA Campaign Number: 15V044000 Component(s): TIRES Potential Number of Units Affected: 5,876 All Products Associated with this Recall Vehicle Make Model Model Year(s) BUICK ENCLAVE 2015 CHEVROLET TRAVERSE 2015 GMC ACADIA 2015 Details Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2015 Buick Enclave vehicles manufactured December 9, 2014, to January 14, 2015, 2015 Chevrolet Traverse vehicles manufactured December 9, 2014, to January 20, 2015, and 2015 GMC Acadia vehicles manufactured December 9, 2014, to January 16, 2015, and all equipped with Goodyear P255/65R18 Fortera HL tires. These vehicles are equipped with tires that may experience tread cracking. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) No. 110, "Tire Selection and Rims and Motor Home/Recreation Vehicle Trailer Load Carrying Capacity Information for Motor Vehicles with a GVWR of 4,536 kilograms (10,000 pounds) or Less." CONSEQUENCE: If the tire treads crack, a loss of tire pressure and possible tire failure may result, increasing the risk of a crash. REMEDY: GM will notify owners, and dealers will replace the tires that were manufactured within a specific date range, free of charge.

2017 Buick LaCrosse an evolution of sharp Avenir concept

After years as a bloated, uninspiring, but comfortable near-premium sedan, Buick has taken the wraps off a leaner, lither, far more stylish LaCrosse. The third-generation model has just made its debut at the 2015 Los Angeles Motor Show. While there's a lot to talk about, let's first address the new, Avenir-inspired sheetmetal. The fascia is basically the concept car smoothed over into production form, featuring the same winged trishield. In place of the chrome-trimmed waterfall, the LaCrosse gets a blacked-out, recessed grille with a chrome surround. It looks good in photos but it's better in person, adding a real sense of complexity and depth to the front end. The headlights and lower fascia, meanwhile, adhere closely to the concept. The same cannot be said of the LaCrosse's tail. While the taillight lighting pattern is similar, the overall shape of the lighting element is radically different, refining the design featured on the back of the Regal. Also gone, sadly, is the Avenir's boattail rear deck. Instead, the LaCrosse gets a small rear deck that curves up into a pleasant duckbill spoiler. The rest of the tail is pleasantly restrained. Perhaps the weakest point is the profile, where Buick has instituted a "split-spear" design, featuring a strong shoulder line above the rear wheel well, which sits below an even stronger character line that curves down and towards the front of the car. It strikes us as just a little too much, like the Impala. Underneath that sheetmetal, Buick has managed to trim nearly 300 pounds of body fat, nearly half of which came from the vehicle's actual structure. That 300 lbs, according to Buick's engineers, is equivalent to a Kenmore side-by-side refrigerator, in case you needed a helpful comparison. Despite the weight savings, Buick has upped the torsional rigidity for this new model by 15 percent. The LaCrosse's cabin features a strong, cockpit-like design, with a high, floating-bridge center console. This is possible due to Buick's adaption of the Electronic Precision Shift system, introduced earlier this month on the new Cadillac XT5. Despite the new-fangled console design, Buick's retained the wraparound cabin style introduced on the second-gen model. Based on a quick crawl around the interior, space is great in front, although ingress in back is somewhat difficult due to the roofline. You're probably wondering why we haven't said anything about the mechanicals just yet.

GM throttles back Chevy Malibu, Buick LaCrosse production over swollen inventories

As inventory of the Chevrolet Malibu and Buick LaCrosse continues to pile up, General Motors will be idling its Fairfax Assembly Plant for two weeks, according to Automotive News. This move comes about a month after the plant was shut down for three weeks in late December and early January for the same reason. As of January 31, the GM had a 94-day supply of Malibu stock while the LaCrosse was a little worse with a 117-day supply.
Just last week, GM announced that it would be investing $600 million in upgrading this plant, but it's unclear what future plans the company has in store for Fairfax considering slow sales of both the plant's models. We do expect a refreshed and more luxurious LaCrosse shortly and an early design update for the Malibu to be announced at some point this year, although we have had no official word as to when either will happen.