Buick Lasabre 2002 on 2040-cars

Auto blog

Opel to be shuttered in China, but will restart Buick production in Germany

Opel, General Motors' troubled German brand continues its quest to reinvent itself and find solid profitability. In the course of that metamorphosis, the company has a bit of good news/bad news today. The good news is, it will once again begin screwing together Buick models for the American market. The bad news, though, is that it's being shut down in yet another country, China.
Let's start with the good news. The last vehicle Opel's Ruesselsheim factory built for the North American market was the early run of the then-new Regal, which is based heavily on the Opel Insignia. Production ran for just over two years, from 2009 to 2011, before moving production to Oshawa, Ontario.
Now, thanks to a 245-million-euro investment (just over $336 million), Opel will kick off production of a unspecified model for the US in the "second half of the decade," according to Automotive News. According to Opel, the new model will be announced before the end of 2014. You can begin your speculation about this new model down in Comments (we're wagering it'll be the Cascada convertible, sold here under the Buick umbrella).

GM recalling nearly 4,000 vehicles over airbag concerns

Four different General Motors vehicles from the 2012 model year are being recalled over a potential airbag issue. The driver's side airbag shorting bar in the 2012 Buick Verano and 2012 Chevrolet Camaro, Cruze and Sonic might make contact with the airbag terminals, even during a crash. If so, the airbag won't deploy when it should, possibly increasing injury to the driver.
The recall is expected to begin on February 13 for the 3,896 units that might be affected. GM will notify owners who can then take their vehicles to dealers to have the airbag coil replaced. A bulletin from the National Highway Traffic Safety Administration below has more info.

2017 Buick LaCrosse an evolution of sharp Avenir concept

After years as a bloated, uninspiring, but comfortable near-premium sedan, Buick has taken the wraps off a leaner, lither, far more stylish LaCrosse. The third-generation model has just made its debut at the 2015 Los Angeles Motor Show. While there's a lot to talk about, let's first address the new, Avenir-inspired sheetmetal. The fascia is basically the concept car smoothed over into production form, featuring the same winged trishield. In place of the chrome-trimmed waterfall, the LaCrosse gets a blacked-out, recessed grille with a chrome surround. It looks good in photos but it's better in person, adding a real sense of complexity and depth to the front end. The headlights and lower fascia, meanwhile, adhere closely to the concept. The same cannot be said of the LaCrosse's tail. While the taillight lighting pattern is similar, the overall shape of the lighting element is radically different, refining the design featured on the back of the Regal. Also gone, sadly, is the Avenir's boattail rear deck. Instead, the LaCrosse gets a small rear deck that curves up into a pleasant duckbill spoiler. The rest of the tail is pleasantly restrained. Perhaps the weakest point is the profile, where Buick has instituted a "split-spear" design, featuring a strong shoulder line above the rear wheel well, which sits below an even stronger character line that curves down and towards the front of the car. It strikes us as just a little too much, like the Impala. Underneath that sheetmetal, Buick has managed to trim nearly 300 pounds of body fat, nearly half of which came from the vehicle's actual structure. That 300 lbs, according to Buick's engineers, is equivalent to a Kenmore side-by-side refrigerator, in case you needed a helpful comparison. Despite the weight savings, Buick has upped the torsional rigidity for this new model by 15 percent. The LaCrosse's cabin features a strong, cockpit-like design, with a high, floating-bridge center console. This is possible due to Buick's adaption of the Electronic Precision Shift system, introduced earlier this month on the new Cadillac XT5. Despite the new-fangled console design, Buick's retained the wraparound cabin style introduced on the second-gen model. Based on a quick crawl around the interior, space is great in front, although ingress in back is somewhat difficult due to the roofline. You're probably wondering why we haven't said anything about the mechanicals just yet.