1990 Buick Lesabre Hearse T1240073 on 2040-cars

Auto blog

Why Mazda did so well and Volvo so poorly in Consumer Reports survey

The poor performances of Tesla and all three domestic automakers got the headlines in Consumer Reports magazine's latest reliability survey, but there were other results that caught our interest. Tiny Mazda notched the biggest gain among the 29 brands included in this year's list, leap-frogging nine spots to No. 3. Buick, which was in the top 10 last year, fell 11 spots to No. 19, the biggest decline of any brand. And then there's Volvo, a brand often vaunted for its quality and reliability, dropping six spots to dead last. What gives? For starters, all three brands benefited or suffered in large part due to their relatively small portfolio of vehicles. So when raves or complaints rolled in for even one particular model, as was often the case, it weighed heavily on the entire brand. That's especially true when it involves a relatively high-volume, hot-selling model such as the Buick Enclave (more on that in a moment). Mazda fared as well as it did despite the CX-3 losing Consumer Reports' influential "recommended" status due to problems with its climate system, including leaks from the condenser and refrigerant unit that triggered a service bulletin from the automaker in late 2016. Deputy auto editor Jon Linkov said that scratch didn't hurt the overall brand, since the CX-9 crossover and MX-5 Miata both jumped up to replace it on CR's list of newly recommended vehicles, thanks to several back fixes Mazda made to both models. For Buick, the redesigned Enclave SUV earned a "Much Worse Than Average" rating after owners reported problems with the new nine-speed automatic transmission it shares with the Chevrolet Traverse as well as some issues with the climate system. There were issues with rough shifting, plus complaints about the torque converter that necessitated fixes to the computer or outright replacement. "Again, similar stuff that we saw with the Traverse: both first-year vehicles, similar powertrains," LInkov said. He said all-new vehicles or redesigns typically fare poorly in CR's reliability survey due to issues that are hard to suss out before vehicles go into everyday use by consumers. The top-selling Encore and Envision fared well, Linkov said, but were outdone by the Enclave's problematic transmission components. The Enclave was Buick's second best-selling model through September at 35,227 units. Then there is Volvo, about which there is one word to sum up its woes: infotainment.

eBay Find of the Day: 1981 DeLorean with 570-hp twin-turbo Buick V6 [w/videos]

"Are you telling me that you built a time machine... out of a DeLorean?" So asked one Marty McFly of his mentor Dr. Emmett Brown, who replied: "The way I see it, if you're gonna build a time machine into a car, why not do it with some style?"
Doc Brown was right, of course: with an exotic mid-engine layout, gullwing doors and stainless steel body, the DeLorean DMC-12 sure looked the part. It just needed a little more juice. Well this one might not have 1.21 gigawatts of time-bending power - that'd be more than one and a half million horsepower - but it does have more than the 150 hp in the the standard 2.8-liter V6.
That's because this particular DeLorean has had its stock Peugeot Renault Volvo engine swapped out for a Buick-sourced, all-aluminum, 4.3-liter V6 from the Grand National. Dutteiller Performance didn't leave the engine in stock form, either: while they were swapping it out, they added a pair of turbochargers, new pistons, crank, cams and much, much more.

GM won't really kill off the Chevy Volt and Cadillac CT6, will it?

General Motors is apparently considering killing off six slow-selling models by 2020, according to Reuters. But is that really likely? The news is mentioned in a story where UAW president Dennis Williams notes that slumping US car sales could threaten jobs at low-volume factories. Still, we're skeptical that GM is really serious about killing those cars. Reuters specifically calls out the Buick LaCrosse, Cadillac CT6, Cadillac XTS, Chevrolet Impala, Chevrolet Sonic, and the Chevrolet Volt. Most of these have been redesigned or refreshed within the past few model years. Four - the LaCrosse, Impala, CT6, and Volt - are built in the Hamtramck factory in Detroit. That plant has made only 35,000 cars this year - down 32 percent from 2016. A typical GM plant builds 200,000-300,000 vehicles a year. Of all the cars Williams listed, killing the XTS, Impala, and Sonic make the most sense. They're older and don't sell particularly well. On the other hand, axing the other three seems like an odd move. It would leave Buick and Cadillac without flagship sedans, at least until the rumored Cadillac CT8 arrives. The CT6 was a big investment for GM and backing out after just a few years would be a huge loss. It also uses GM's latest and best materials and technology, making us even more skeptical. The Volt is a hugely important car for Chevrolet, and supplementing it with a crossover makes more sense than replacing it with one. Offering one model with a range of powertrain variants like the Hyundai Ioniq and Toyota Prius might be another route GM could take. All six of these vehicles are sedans, Yes, crossover sales are booming, but there's still a huge market for cars. Backing away from these would be essentially giving up sales to competitors from around the globe. The UAW might simply be publicly pushing GM to move crossover production to Hamtramck to avoid closing the plant and laying off workers. Sales of passenger cars are down across both GM and the industry. Consolidating production in other plants and closing Hamtramck rather than having a single facility focus on sedans might make more sense from a business perspective. GM is also trying to reduce its unsold inventory, meaning current production may be slowed or halted while current cars move into customer hands. There's a lot of politics that goes into building a car. GM wants to do what makes the most sense from a business perspective, while the UAW doesn't workers to lose their jobs when a factory closes.