2007 Bmw 525i Base Sedan 4-door 3.0l on 2040-cars

Auto blog

BMW 1 Series with B38 three-cylinder engine

Downsizing For BMW's Front-Wheel-Drive And i Futures
Output is quoted at 175 horsepower and BMW says it will hit 62 mph in 7.0 seconds.
The red five-door BMW 1 Series seen in this photo gallery has little to do with what is actually of importance here. What we've just tested at an airfield not far from Munich, Germany, is a new 1.5-liter TwinPower Turbo inline three-cylinder gas engine that we'll be hearing an awful lot about in the coming few years.

2014 BMW 4 Series

Because Four Is Greater Than Three
Say what you will about the name 4 Series, there is a method to BMW's madness. On one hand, it's easy enough to just buy into the logic that odd numbers are reserved for sedans and wagons, and that even numbers are reserved for coupes and convertibles. On the other hand, consider the idea that the higher numbers are used to separate the more dynamic, more engaging vehicles that use the same platform. It's that sort of separation that differentiates the 6 Series so nicely from its 5 Series roots, after all. And if we're being cynical, it also allows BMW to charge a bit more money for its lower-volume offerings.
So with the new two-door version of the 3 Series, BMW has gone the route of strengthening the dynamic virtues of its F30 chassis to create a car that's more removed from its sedan kin than one might think. And after spending some time with the new 4 Series on the roads around Lisbon, Portugal, as well as the famous Circuito do Estoril racetrack, it's increasingly clear that calling this car a 3 Series Coupe simply wouldn't be fair.

Researchers halfway to cutting carbon fiber costs by 90%

Carbon fiber has been utilized for decades to build racecars, as a means to cut weight while maintaining strength. But until recently, the space-age material has been largely absent from the street on anything but supercars because of the expense to use it. Recently, BMW signaled a major shift in that trend when it starting using carbon fiber reinforced plastic panels on the i3 and i8. This relatively small scale start might be just the beginning; the German company believes that a breakthrough to inexpensively manufacture the lightweight stuff is just on the horizon.
MAI Carbon Cluster Management GmbH counts BMW, Audi, Airbus, the German government and many other organizations as supporters, and it's researching how to make carbon fiber cheaper to produce, according to Automotive News Europe. The company thinks it can reduce costs by 90 percent in the near future. "We've certainly reached a halfway point on our cost-cutting target for suitable carbon-fiber parts," said project head Klaus Drechsler to Automotive News Europe.
Unfortunately, it isn't entirely clear just what MAI Carbon is doing to make such a huge leap possible. However, a recent post on the company's website talks about a new form a carbon fiber using a thermoplastic matrix that could be cured in less than three minutes. That's compared to about 90 minutes in the traditional process with an autoclave.