Make Your Best Offer... Technology Package.. Only 35k Miles.. One Owner.. Clean on 2040-cars

Auto blog

Acura RDX Luggage Test | How much cargo space?

The Acura RDX is considered a compact luxury SUV, but there's actually very little that's compact about it. When lined up against its competitors, you can see that it enjoys a clear dimensional advantage. In fact, the RDX is pretty close to the Lexus RX, with an identical rear legroom figure and considerably more cargo space with the back seat raised. Obviously, I'll be addressing the latter here. On paper, Acura provides several cargo numbers calling out specific SAE measurement standards for each one. Basically, it has 31.1 cubic-feet behind its back seat when you include its underfloor storage and 29.5 cubic-feet when you don't. Even that smaller number is superior to everything in the segment save the Volvo XC60 (29.7), while the Lexus RX apparently has a seems-way-too-small 18.4.   Let's see what that size advantage means. It's obvious that this is a comparatively deep and wide space with plenty of air above the back seat line for bulkier items. Note that the cargo cover was not present in this test vehicle, so I couldn't test capacity with it in place. As in every luggage test, I use two midsize roller suitcases that would need to be checked in at the airport (26 inches long, 16 wide, 11 deep), two roll-aboard suitcases that just barely fit in the overhead (24L x 15W x 10D), and one smaller roll-aboard that fits easily (23L x 15W x 10D). I also include my wife's fancy overnight bag just to spruce things up a bit (21L x 12W x 12D). There you go, all the bags fit easily. This is pretty much identical to the Lexus RX (below left) and a much easier fit than the Mercedes GLC, which is  one of the only other compact luxury models I've tested. Both of these examples are more capacious than their specs would indicate. However, this is not the end of the RDX story. Remember when I mentioned that it has 31.1 cubic-feet when including its underfloor storage? Well, that might actually be underselling the extra space gained. First, I like that the floor flips back and rests flat so you can easily use the extra space. You can also fully remove the floor piece to gain access to the aft bin, which is deeper but oddly shaped.  Here are my four largest bags standing up, with sufficient rear visibility maintained, and you still have the full-width section of the cargo area including the underfloor bin. What can you fit there? How about a 38-quart cooler and the remaining two bags stacked haphazardly around it.

2015 Acura TLX launch delayed

Last week in New York, Acura pulled the wraps off its all-new TLX sedan - a midsize model that replaces both the TSX and TL in one fell swoop. In a bit of behind-the-scenes full disclosure, we were originally scheduled to get our first drive of the car in early May. But an intrepid reader forwarded us an email to Acura dealers saying that the on-sale date of the TLX will be pushed back, and subsequently, the automaker confirmed to Autoblog that the official media launch has been postponed, as well. Acura spokesperson Chuck Schifsky tells us that the 2015 TLX will now go on sale later this summer.
"We don't view it as a major delay," Schifsky told Autoblog. The TLX is "the most technologically advanced Acura" yet - even more so than the original NSX, Schifsky says - and thus, there are "lots of systems to get sorted out." When asked if there is a specific component to point to regarding this delay, Schifsky told Autoblog that it's "not any one thing."
"We have determined that it is necessary to modify the production schedule for the 2015 TLX, which will move the on-sale date to late summer."

Acura NSX will use Cosworth block, plus other neat tidbits

The blue NSX you see here was built just two weeks ago. Prototype number six, it rolled off Acura's newest assembly line in Ohio and was rushed out to the Monterey peninsula for various car week activities. We had a chance to sit down with several members of the NSX team to discuss the car, the long road from concept to production, and some interesting details. Below are some choice bits from our conversations. Acura is pretty proud of the fact that NSX version 2.0 was designed and is being built in the US. The new assembly line, called the Performance Manufacturing Center, is in Honda's hometown of Marysville, Ohio. While the line is brand new, the building has seen many uses over its lifetime, most recently as a warehouse facility. PMC staff numbers about 100, with 60 technical and 40 non-technical associates. The car uses parts sourced globally, and one of those sources is Cosworth. The engine blocks and heads come from the English firm and get assembled into twin-turbo powerhouses at Honda's nearby Anna, Ohio, engine plant. The Cosworth name is rarely associated with a bad engine, so we were geeked to hear the NSX's 550-plus-horsepower hybrid powertrain has good genes. Acura hasn't decided how many cars will come to the US each year, but supplies will be limited. We're told there is a total figure for global sales – basically anywhere Honda and Acura vehicles are sold – but they're not ready to divulge that number. Dealer allocation is also yet to be sorted out, although we're told that any dealer that has the necessary tools and equipment to service the new NSX will be able to sell them. Acura currently has 272 US dealers. The switch from the transverse engine originally planned to a longitudinal twin-turbo engine threw everyone involved for a loop. The designers had to lengthen their nearly finalized design, and the engineers working on the production process had to revise or redo much of their work. Though we've been waiting a while for the car since the concept first surfaced in 2012, it's pretty amazing to think that the car was engineered one and a half times and a new factory was built in about three years. But yeah, it's delayed, with series production now set to commence in the spring of 2016. One result of the switch to a longitudinal engine is a transmission hump in the cargo area aft of the engine. The hold is still sized to fit a bag of golf clubs, though it will be a tight fit.