Gmc 96 Suburban Slt - 4wd, A/t 5.7v8l, A/c, Loaded, 121k Runs Great! No Resv on 2040-cars

Auto blog

GM recalls 51k Enclave, Traverse, Acadia crossovers over fuel gauge inaccuracy

With all eyes fixed on General Motors in the wake of the ignition recall debacle, the auto giant has been carefully calling in a wide array of vehicles to fix anything and everything that could prove problematic. Just the other day it issued two separate recalls - one concerning the Cadillac SRX and another its heavy-duty pickups - and now it is issuing another.
This time the vehicles in question are the Buick Enclave, Chevy Traverse and GMC Acadia, three fullsize crossovers based on GM's Lambda platform. In an estimated 51,640 units manufactured between March 26 and August 15, 2013, the engine control module has been found to incorrectly display the level of fuel in the tank.
As a result, owners are being notified to bring their vehicles in to their local dealers to have the ECU reflashed to fix the problem. View the full details in the announcement below from the National Highway Traffic Safety Administration.

GM recalling 118K Colorado, Canyon pickups over missing hood latches

General Motors has announced a recall of 118,800 Chevrolet Colorado and GMC Canyon pickup trucks due to the possibility of secondary hood latches not being installed at the time of manufacture. The affected vehicles are from the 2010, 2011 and 2012 model years, all of which were built between November 9, 2009 and August 28, 2012.
According to the official National Highway Traffic Safety Administration report, these trucks fail to "comply with the requirements of Federal Motor Vehicle Safety Standard No. 113, 'Hood Latch System.' The hood may be missing the secondary hood latch." In other words, owners of these trucks could find their vehicles' hoods opening unexpectedly while driving.
The official recall campaign is expected to begin on January 17, 2013. Dealers will inspect the affected pickups and if a secondary hood latch is not present, one will be installed free of charge. Scroll down to read the official NHTSA report.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck