1968 Ford Thunderbird Base Sedan 4-door 7.0l on 2040-cars

Auto blog

Ford Fiesta 1.0L EcoBoost sales robust in early going

Okay, okay, okay, so I was just a smidge wrong. Those that read my review of the Ford Fiesta with the new 1.0-liter, EcoBoost engine will know that while I really enjoyed the torquey little three-cylinder, I was concerned that Ford's decision to force 1.0-liter owners into a manual transmission, steel wheels and one trim level might hurt sales of the new engine. I was also concerned that the promised 45-mile-per-gallon highway rating wouldn't be enough to tempt buyers into trying an engine that's so far outside of what the general public is use to. My concerns, though, seem to have been for naught.
While not doing a booming business on the triple-equipped Fiesta, Ford is seeing a take rate of four to eight percent per month in the engine's first few months on sale. Now, four to eight percent might not sound like a lot - if, like last year, the Fiesta sells around 71,000 units, there'd be barely 5,600 1.0-liter models on the road. It is also small potatoes relative to the take rate on EcoBoost-equipped vehicles across the Ford range, which US sales analyst Erich Merkle estimates to be roughly 35 to 40 percent of retail sales. Still, according to The Detroit News, the 1.0-liter is getting adopted at roughly the same rate as the sparkling Fiesta ST, which should be a solid indication of just how well this little engine is doing.
The 1.0-liter's success "really speaks volumes, not just to what we're doing with the Fiesta, but with EcoBoost in general," Merkle told Autoblog.

Ford F-100 'Snakebit' shown off by Gene Simmons and Shannon Tweed at SEMA

Ford, along with KISS bassist Gene Simmons and his wife, Shannon Tweed, used SEMA as a backdrop to pull the covers off Snakebit, a 1956 Ford F-100 pickup truck that's been updated with Shelby Mustang-derived styling bits and a 5.4-liter supercharged V8 engine. All 550 horsepower are funneled through a six-speed manual gearbox to the rear wheels.
Underneath the custom bodywork sits a chassis that's been stretched five inches and a bed widened and bedecked with billet machined pieces that are supposed to look like wood. The 20-inch rear and 18-inch front wheels ape those of past Shelby Mustang models. The interior is swathed in two-tone leather with a bench seat designed to look - try to act surprised - like a Shelby Mustang.
Like what you see? Bidding for the truck will take place in 2014 at an unspecified Barrett-Jackson event (we'd assume Scottsdale). Proceeds will be used to help build a children's hospital in Saskatoon, in the province of Saskatchewan, where Ms. Tweed grew up. See the high-res gallery above and the press release down below for more.

NHTSA investigating Ford's solution to May 2014 power steering recall

The National Highway Traffic Safety Administration is investigating a complaint that Ford's response to a May 2014 recall of the 2008 to 2011 Ford Escape and Mercury Mariner doesn't quite go far enough to solve a troubling power-steering problem. Roughly a year ago, Ford recalled nearly a million vehicles after it was found that a problem with the torque sensor's communication with the power steering control module could cut steering assistance for drivers. While manual steering would still be available, the problem was enough to ask drivers to report in to have the PSCM inspected, and if necessary, replaced (along with the torque sensor, or in dramatic cases, the entire steering column). That would only happen, though, if trouble codes were being thrown. If there weren't any problems, dealers were told to simply update the PSCM's software so that any issues between it and the torque sensor would simply throw a visual and audio warning – power steering would still be maintained. The petitioner claimed that following the recall work, he still experienced a problem with the torque sensor. According to NHTSA, a claim was made that Ford didn't go far enough in its solution to the problem, and that "the software update itself may in fact cause further issues with the affected vehicle's power steering, causing it to fail, and ultimately requiring replacement of the torque sensor or entire steering column." The petition was filed in early February and is now officially being looked into by NHTSA.