2012 Dodge Ram 4500 Crew Diesel Dually Sleeper Cab 4k Texas Direct Auto on 2040-cars

Auto blog

FCA recalls 894k total vehicles worldwide in two campaigns

FCA is recalling a total of 893,698 vehicles worldwide in two campaigns to fix problems with inadvertent airbag deployment, failure of the anti-lock brakes, and stability control systems in the Jeep Grand Cherokee, Liberty, Dodge Journey, and Fiat Freemont. 559,703 of these vehicles are in the US. The larger recall affects 284,089 examples of the 2003 Jeep Liberty and 2004 Jeep Grand Cherokee, and there are also 13,411 of them in Canada, 6,277 in Mexico, and 48,212 outside the NAFTA region. Because of "electrical noise beyond the tolerance of the airbag electronic control module", part of that component can fail, according to the National Highway Traffic Safety Administration. This can cause the front and side airbags to deploy and the seatbelt pre-tensioners to activate inadvertently. FCA US has seven reports of alleged injuries from this problem. To fix the situation, the Jeeps need their Occupant Restraint Control modules replaced, as well as the front- and side-impact sensors. According to the NHTSA, the replacement parts won't be available until early 2016. Still, FCA US will advise owners about the problem in a letter by the end of December and will send a second notification when the components are ready. The second campaign affects 275,614 examples of the 2012-2015 Dodge Journey in the US; plus 78,148 of them in Canada, 36,471 in Mexico, and 151,476 left-hand drive units outside of NAFTA where it's sold as the Fiat Freemont. On these vehicles, water intrusion can disable the anti-lock brakes and electronic stability control, although a warning light often illuminates when this issue occurs, and the problem doesn't affect regular braking. There are also no reports of injuries or accidents. To fix the issue, dealers will seal the ABS wiring harness and will replace any already affected components as necessary, like the ABS module or the headlamp and dashboard wiring harness. Statement: Occupant Restraint Control Modules October 30, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 284,089 older-model SUVs in the U.S. to replace their Occupant Restraint Control (ORC) modules and front and/or side-impact sensors, as required. Within this vehicle population, FCA US became aware of seven injuries caused by inadvertent air-bag deployments and advised NHTSA accordingly. The affected vehicles are not equipped with Takata Corp. air-bags. The Company is unaware of any related accidents.

Chrysler banks $507 million in Q2, trims 2013 earnings forecast

Chrysler has some good news and some bad news. First, profits were up 16 percent over the second quarter of 2012, bringing the Auburn Hills, Michigan-based manufacturer $507 million on the back of strong demand for trucks and SUVs (a recurring theme this quarter, particularly in the US). Q2 revenue was up as well, from $16.8 billion in 2012 to $18 billion in 2013. The bad news is that the Pentastar's overall earnings forecast for net income in 2013 has been trimmed from $2.2 billion to between $1.7 and $2.2 billion, according to Automotive News.
In addition to the adjusted net income forecast, Chrysler tweaked its operating profit from $3.8 billion to between $3.3 and $3.8 billion. This has gone largely unexplained by Chrysler, perhaps hoping the news of a three-percent increase in its transaction prices for Q2 will allow it to sweep this adjustment under the rug.
The star of the show for Chrysler has been its US sales, which saw a 10-percent jump, both bettering the industry average of eight percent and improving over the same stretch of 2012. As with the increase in transaction prices, Chrysler has the new Ram pickup and Jeep Grand Cherokee to thank. Perhaps most worrying from this report, though, is that every brand in the automaker's stable saw an increase in sales... except for the Chrysler brand itself.

Dodge idles Viper production again at Conner Avenue

You've got to hand it to Dodge for having the gumption to put the original Viper into production in the first place. It was, after all, much more of an emotional decision than a practical one, and a move which saw the first production V10 engine placed in a road car - long before the advent of the Lamborghini Gallardo, Audi R8, Porsche Carrera GT or Lexus LFA, not to mention the other Ford, BMW and Volkswagen Group models that used such engines.
It's now been 22 years since the first Viper entered production and the Viper still rolls on several generations later, but we're sad to say that courageous decision has not always been met with overwhelming sales success. In fact parent Chrysler was forced to idle the Conner Avenue plant where the Viper is made back in April due to slow sales. And while production resumed again as planned on June 23, it apparently didn't do the trick.
As a result, Chrysler corporate communications chief Shawn Morgan revealed to Autoblog that the assembly line has been shut down again for another two weeks. The line was up and running for nearly two full work weeks from June 23 until the holiday weekend that started on Thursday, July 3. But instead of coming back online today as planned, it's been idled again for the weeks of July 7 and 14. That means it will be July 21, at the earliest, before the serpentine supercars start slithering down the assembly line at Conner Avenue again. Once it does, however, production is set to resume at the same pace it was before the shutdown.